Lesson 8 - Getting Ready to Spray Tan

55 %
45 %
Information about Lesson 8 - Getting Ready to Spray Tan
Health & Medicine

Published on November 20, 2013

Author: RichardBrown6

Source: slideshare.net

Description

Setting up the airbrush
Preparing the treatment area
Maintaining the clients modesty
How long should it take?

Getting ready to Tan A publicatio n of

Lesson 8 Getting ready to Tan A publicatio n of

INTRO In this lesson you will learn:

INTRO In this lesson you will learn: •Setting up the airbrush

INTRO In this lesson you will learn: •Setting up the airbrush •Preparing the treatment area

INTRO In this lesson you will learn: •Setting up the airbrush •Preparing the treatment area •Maintaining the clients modesty

INTRO In this lesson you will learn: •Setting up the airbrush •Preparing the treatment area •Maintaining the clients modesty •How long should it take?

Before the treatment..

1 Warm it up

1 Warm it up Before the treatment begins, warm up the room, a fan heater will help dry the tan.

2 Ventilate

2 Ventilate Provide ventilation; switch extractors on, open the windows, comply with local byelaws.

3 Floor

3 Floor Protect the floor (cover with something disposable or washable), but make sure it is not slippery.

4 Position the compressor

4 Position the compressor Make sure the compressor is positioned as far away from the tanning area as possible, this will avoid the tan being sucked into the motor resulting in permanent damage to the machine, the manufacturers will not cover this in the guarantee as it is misuse

5 Test it

5 Test it There is nothing worse than the equipment failing, so test it out now and have a back up plan.  Make sure all electrical equipment is safe.  Do not leave wires where they form a tripping hazard.

6 Set the preasure

6 Set the preasure Set the pressure or spray diameter if necessary.

7 Test

7 Test Test that the airbrush is spraying correctly

8 Gloves

8 Gloves Pop on a pair of disposable gloves.

9 Fill the cup

9 Fill the cup Pop the cup on a flat surface and fill (do not overfill it) with 50ml to 80ml depending on the manufacturers instructions.

10 Tighten the lid

10 Tighten the lid Carefully fasten the lid on, ensuring no cross threading occurs as this may damage the cup.

11 Adjust the flow rate

11 Adjust the flow rate Adjust the flow rate a little at a time so that only a small amount of fluid is being released, when the trigger is activated.

12 Flow rate

12 Flow rate An HVLP flow rate will decrease if the fluid adjusting screw is turned to the right and increase the screw is turned to the left.

13 Trigger

13 Trigger If the trigger is a little sticky loosen it off and pull it back and forth a few times. Don’t forget to reset it before the next tan

14 Keep it level

14 Keep it level Which ever system being used, KEEP THE GUN LEVEL to avoid tan spilling from the cup or the spray becoming un-even. The number one reason for airbrushes leaking is because the spray tan pro has tipped the airbrush during treatment.

Keep clients happy

Keep clients happy 1. If at the last minute the client is un-prepared use the exfoliating mitt, pre-tan prep spray and make-up remover wipes.

Keep clients happy 1. If at the last minute the client is un-prepared use the exfoliating mitt, pre-tan prep spray and make-up remover wipes. 2. Once ready to start the treatment, leave the client to get changed, provide disposable pants and bra and leave the room, at this point hands should be washed.

Keep clients happy 1. If at the last minute the client is un-prepared use the exfoliating mitt, pre-tan prep spray and make-up remover wipes. 2. Once ready to start the treatment, leave the client to get changed, provide disposable pants and bra and leave the room, at this point hands should be washed. 3. On return, knock and ask the client if they are ready, once confirmed, enter the room and lock the door.  Keep checking the client’s well being at regular intervals throughout the treatment

How long to take?

How long to take? 1. The consultation should take around 5 minute.

How long to take? 1. The consultation should take around 5 minute. 2. The treatment should take around 10 minutes.

How long to take? 1. The consultation should take around 5 minute. 2. The treatment should take around 10 minutes. 3. Drying Time/Clean up/ Rebook should take around 15minutes

… AND YOU’RE DONE...

… AND YOU’RE DONE... ....Now you can move on to your next lesson!

So you want to become a spray tan technician, and you want it to drive more business …?

So you want to become a spray tan technician, and you want it to drive more business …? can help with that.

Add a comment

Related presentations

Related pages

Spray Tanning Tips - Glistening Goddesses

• If you take your bra off when you're getting sprayed, ... • If you are wearing your spray tan to bed, ... Spray Tanning: Spray Tanning Tips/FAQ: Parties:
Read more

My First Time: Spray Tanning - Spry Living

... I decided to try getting a spray tan. ... The night before my first time spray tanning, ... I was ready to get inside the booth.
Read more

Custom Spray Tan | Natural Looking Self Tanners | Mystic Tan

Trust Mystic Tan to create a signature look for every style, mood, season and event. ... inhalation or ingestion during a spray tan session, such as:
Read more

how Kim Kardashian achieves her signature tan - Us Weekly

Kim Kardashian told Us Weekly that her adorable 13-month-old daughter North West ... [getting ready] ... "I used to spray tan more before I got ...
Read more

Spray Tanning Tips - Frequently Asked Questions (FAQs)

Spray tanning tips. ... Will spray tan protect me from getting a sunburn? ... about 8 hours.
Read more

How to Spray on a Tan | eHow

How to Spray on a Tan. ... The dead skin is washed away and your fresh skin is ready ... One of the safest ways to get a glowing tan is by getting spray ...
Read more

Spray Tanning Tips |Spray Tanning Facts - Spray Tan Byron Bay

... Will spray tan protect me from getting a ... more spray tanning tips before spray tan ... a smooth silky skin ready for your spray tan ...
Read more

Tan Physics True Color || Best Self Tanner || Best Sunless ...

As of 8:14am EDT, July 13, 2016 ... Sure you get a tan from spray ... increase the depth and natural color of your tan. Tan Physics True Color was ...
Read more

MicroMist® | NEUTROGENA®

MicroMist Airbrush Sunless Tan Flawless, sunless, ... Face. Do not spray MicroMist directly on your face. Spray into your hands and then apply with your ...
Read more